AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Onkyo Software Update3/27/2021
If any numbers differ from the latest version available, please update your unit.Once the update begins, dont turn off the power supply to the AV receiver until it is time to restart it.If the update is not completed within two hours, turn off the power supply by pushing the ONSTANDBY button and then try updating again from the beginning.Note that the update may fail, or cause problems for your AV receiver, if you do any of the following.
Onkyo Software Update Your UnitIt went into the local repair center since it was still under warranty. Everything else seems to be working fine Any ideas or tips to fix this Thanks in advance. I cant recall if files were zipped needed unzipped etc.but I updated all mine usb no issues. I never had to use usb on my Onks, but they were older models. If you do go usb,I am pretty sure you have to unzip the files, but not 100 sure. I just do the USB cause it should be failproof unless there are hardwarefile issues. Clear will appear on the display and the AV receiverAV amplifier will enter Standby mode. I use it everyday and have had zero problems with it in two years. I must have been one of the minority when it comes to this brand because everyone touts them so much. I have had a good experience and that makes me a cheer leader for Onk, but I think I am in the minority. I told myself that maybe it was the OTHER units that had bad HDMI boards, but it is now well known that they are ALL defective, and failure is not a matter of if but when. My problem is they wont deal with the problem before it has a problem, they require the AVR to fail before they will replace the board. ![]() And these big box stores dont do anything to educate their employees to then educate us the buyer. That is one of the biggest reasons I stuck with Yamaha so long, they are very reliable. Had I known all the issues the newer receivers would have, I would have stuck with my Yammie RX-V2095. Only reason I sold it was because I got caught up in the whole HDMI push.Ive been tempted several times to repurchase one online. ![]() Onkyo sent a shipping box to me and I received the unit back two days ago. It seems that there were issues with the Texas Instruments chips though. The analog audio became intermittent after the video went out. It could only be done via usb which is what i used and it kill the hdmi output.
0 Comments
Read More
Leave a Reply. |